Catch up
OK - so loads has happened since my last post. In terms of progress on the new stuff, I've been chipping away at it. Got both sides of the bodywork finished and cut out, and then moved onto the rear part and got that finished so thats all a good result! Then finally, my uprights came back, allowing me to do this: And then tonight I managed to find a place to sit! I'm also still working on the engine - I resealed the windage plate and the sump and all was going well, until I went to torque the final bolt up to spec and it snapped Leaving this looking mostly done, but I think I am going to pull it off again, re-clean, re-do and re-seal the whole lot. Alternatively - I am hoping Raptor might service and refurbish the engine for me. I'm really not crazy about the job, and honestly they would do a way better job of it than I will, with the added peace of mind for me. I'm just waiting on Andy to come back and confirm thats an option and I'll whisk the engine away to him