Breaking the Donor

-

 Originally, I wasn't going to be doing this, but circumstances dictated otherwise and certain things aside, I have quite enjoyed the process.


The most satisfying moment


And success!!!!


Main bits all together


Boxes of stuff


More stuff


Most of an engine.


Comments

Post a Comment

Popular posts from this blog

Been a while

-
Image
  It's been ages since I posted. The combination of holidays, not getting a lot done on teh car, and then getting things done in fits and starts has meant that I am no-where near where I wanted to be at this point, but never mind. So, to recap; Last time I put something up, this was the state of the car. Now I look back at it, in that time, I have done quite a lot. Not TOO long after the previous picture, I put the engine in with the help of another builder, Chris. Now you may remember that I was refurbishing the engine last time I posted. I changed direction on that a little bit and got some professional help which I will do a separate post about in the not too distant future. The long and short of it is that I now have a nicely refurbished engine that is installed! However, the fact that the engine is effectively a clean slate now, means I can't just throw some fluids in and start her up, I need to do a proper run-in process.  What that in turn means is that I need to have t...
Read more

Frustration

-
Image
While I said I enjoyed breaking the donor, I may have oversold that a bit. Pulling the engine out was deeply satisfying. Fighting with every. single. part of the donor since is somewhat less so. The car is from just before the turn of the century, so there is the best part of 22 years grime, corrosion, and just general gunk gumming everything up. The gearbox looks in great shape. It really just needs a good brush, a clean with some brake cleaner and then paint. Check. The engine looks OK. The previous owner assures me it runs fine and there is no reason not to believe him to be honest. Problem is he had already taken it apart a certain amount. That makes it a bit difficult to put back together but lets assume I can manage that with some guidance. The diff is fine. It's gone off for strengthening, but its in reasonable nick and its an LSD which is nice. The driveshafts, most of the ancilliaries and anything from the interior are fine. The uprights and hubs look like they are closer ...
Read more

Catch up

-
Image
 OK - so loads has happened since my last post. In terms of progress on the new stuff, I've been chipping away at it. Got both sides of the bodywork finished and cut out, and then moved onto the rear part and got that finished so thats all a good result! Then finally, my uprights came back, allowing me to do this: And then tonight I managed to find a place to sit! I'm also still working on the engine - I resealed the windage plate and the sump and all was going well, until I went to torque the final bolt up to spec and it snapped Leaving this looking mostly done, but I think I am going to pull it off again, re-clean, re-do and re-seal the whole lot. Alternatively - I am hoping Raptor might service and refurbish the engine for me. I'm really not crazy about the job, and honestly they would do a way better job of it than I will, with the added peace of mind for me. I'm just waiting on Andy to come back and confirm thats an option and I'll whisk the engine away to him ...
Read more